Water pressure enables water to flow to homes and businesses
Water pressure helps us move water from the River Murray, our reservoirs, bores and other supply systems through pipes to our treatment plants, storage tanks, mains, and ultimately our customers' taps.
Water pressure can vary
The water pressure at your home or business can be affected by many things, such as whether you are located at the top or bottom of a hill, as well as the distance from a reservoir, storage tank or water main.
It is normal for water pressure to vary across South Australia, due to differences in the local terrain, as well as the various types of infrastructure we use to deliver water across our large network.
Low water pressure/flow
If your water pressure/flow of water is too low, first check there isn’t a problem with the plumbing at your property, such as a partially closed internal stop tap (if fitted) or a leak. To help, see how to locate a leak on your property.
Planned works by our crews or main breaks may also temporarily reduce your water pressure. Check our list of current outages and planned works to see if your area is impacted. Once works are complete, your water pressure should return to normal levels and the water flow will improve.
Measuring your water flow at home
We aim to provide a minimum of approximately 27 litres of water per minute at your water meter. You can test your water flow rate by following these steps:
- Turn off all taps and water-using devices such as washing machines or dishwashers.
- Locate your water meter and open the lid.
- Take a reading by writing down the last three red numbers displayed on your water meter.
- Fully turn on your front garden tap for one minute.
- Turn off the tap and take another meter reading, and subtract the first reading from the last. This will tell you how much water you used within a minute.
- If you receive at least 27 litres a minute or more from your front garden tap, you have an adequate water flow.
If you believe you are receiving less than this, have noticed your water pressure has significantly changed, or if it’s causing issues for you, please report a fault using our online form or call our Customer Care Centre on 1300 SA WATER (1300 729 283).
High water pressure
Since November 2005, the national plumbing standard AS/NZS 3500.1 has required all new water connections to be fitted with a pressure limiting valve (PLV), where water pressures exceed 500Kilopascals (kPa). If your property was built before this time and the water pressure inside your home is greater than 500 kPa, we recommend contacting a plumber to install a PLV at your premises. This can help protect your internal pipework and appliances.
Our drinking water supply systems are subject to the requirements of the Water Services Association of Australia WSA 03-2011 code, including acceptable pressure standards.
Our Customer Contract (Obligations: Section 7.2 - Water Reliability) details our responsibilities to provide customers with a water flow rate that meets their needs.
Water Supply On
- 18/06/2020 03:05 PM - We are attending to an incident in Arthurton with no interruption to the water supply. The safety of our crews and customers comes first, and we always aim to minimise inconvenience by restoring services as quickly as we can. Reference Number WO: 07505663.
- See all major faults
Temporary Supply Interruption
- Estimated start time and water supply off: 15/06/2021 09:00 AM
Estimated restore time and water supply back on: 15/06/2021 04:00 PM
We’re improving your services and undertaking maintenance work in Elizabeth East. Sometimes our crews need to temporarily interrupt the water supply to our customers and/or manage traffic while they are working. Temporary traffic management may remain in place until reinstatement of the impacted road is complete. We always aim to minimise inconvenience by restoring services as safely and quickly as we can.
- See all scheduled works